产品特点 FEATURES

1 DC input range:18–36V

2 Isolated output

3 Input surge withstand:50V for 100ms

4 DC output:24V

5 Output power:200W

6 Regulation:±0.5% no load to full load

7 Efficiency:Up to 89%

8 Maximum operating temperature:100°C (full load)

9 Power density:Up to80W per cubic inch

10 Height above board:0.43in (10.9mm)

11 Parallelable with N+M fault tolerance

12 Low-noise ZCS/ZVS architecture

13 RoHS compliant (with F/G pin option)

14 Programmable output:10–110% of nominal voltage

15 Operation to16V at75% power after startup

16 Agency approvals: cURus, cTÜVus, CE, UL60950-1, EN60950-1, CSA60950-1, IEC60950-1, UKCA

使用场景 APPLICATIONS

1 Industrial and process control systems: Provides stable, isolated power conversion for automated production lines, sensor networks, and control panels.

2 Distributed power systems: Suitable for modular power architectures where multiple converters are paralleled to achieve higher power capacity and redundancy.

3 Medical equipment: Applicable to non-life-support medical devices (e.g., diagnostic tools, laboratory testing equipment) requiring reliable power.

4 Automatic Test Equipment (ATE): Delivers precise and consistent power to test instruments and measurement systems.

5 Communications systems: Powers telecom infrastructure components such as routers, switches, and base station peripherals.

注意事项 PRECAUTIONS

1 Installation: Ensure proper mounting with adequate thermal management (baseplate cooling) to keep operating temperature below 100°C under full load. Follow recommended soldering methods (refer to Vicor's Maxi, Mini, Micro Design Guide).

2 Operational: Do not exceed the maximum rated output current or power. For dynamic loads exceeding 25% of the rated current, consult Vicor Applications Engineering. Avoid input surge voltages beyond 50V for more than 100ms.

3 Voltage trimming: When trimming output voltage down, reduce available output power proportionally; when trimming up, reduce maximum output current proportionally to avoid exceeding rated power. Do not trim above 110% of the nominal output voltage.

4 Parallel operation: For paralleling more than three modules, use a transformer-coupled interface or PR buffer circuit (refer to the design guide). Ensure all PR pins are properly interfaced for current sharing.

5 Safety compliance: This product is not authorized for use in life support devices or systems without Vicor's prior written approval. Follow agency requirements (e.g., use an appropriate fuse in series with the +Input terminal).

V24B24C200BN2-PDF数据手册-参考资料