产品特点 FEATURES

1 High power modular design: NMP1K2 model supports up to 1200W total output with 6 slots for flexible configuration (compatible with NMS-240 single output and NMD-240 dual output modules)

2 Wide input range: Accepts 90~264VAC or 120~370VDC, suitable for global applications; Frequency range 47~63Hz

3 High efficiency: Up to 91% efficiency at full load with H/K modules (24V/48V nominal voltage), reducing energy loss and heat generation

4 Comprehensive safety compliance: Meets medical (2x MOPP isolation) and ITE standards (ANSI/AAMI ES60601-1 Ed3.1, UL62368-1, TUV EN60601-1 Ed3.1, etc.)

5 Robust protection: Overload (constant current limiting), overvoltage (shut down, re-power recovery), over-temperature (auto-recover after cooling)

6 Flexible control: Global ON/OFF (RC1 pin) and local module ON/OFF (RC2/RC3 pins) for precise power management

7 Advanced signaling: DC OK (module output status), T-Alarm (over-temperature alert), current sharing (CS pin for parallel modules)

8 Auxiliary power: +5V-AUX_P (2A for NMP1K2) and Vcc2 (5V/10mA for modules) for external control circuits

9 Compact size: Front-end unit (250*127*41mm, ~2kg) and modules (118.5*37.9*18mm) fit space-constrained installations

使用场景 APPLICATIONS

1 Industrial automation: Powering PLCs, sensors, actuators, and control panels with multiple voltage needs

2 Medical equipment: Compatible with diagnostic instruments, patient monitors, and lab devices (due to 2x MOPP isolation)

3 Telecommunications: Supporting routers, switches, and base stations requiring stable configurable power

4 Test & measurement: Providing adjustable voltages for testing electronic components

5 Data centers: Powering server peripherals or distributed systems with varying power requirements

6 Renewable energy: Integrating with solar/wind systems (DC input) to supply AC-derived DC voltages

7 Industrial IoT: Powering connected devices in smart factories or industrial networks

注意事项 PRECAUTIONS

1 Installation: Ensure proper grounding; Use M4 screws (front-end) and M3.5 (modules) with recommended torque (12Kgf-cm/10Kgf-cm)

2 Derating: Follow derating curves for ambient temps above 50°C or below -15°C (output <12V)

3 Global ON/OFF: Assemble shorting connector (RC1 to GND-P) if not using global control; No output otherwise

4 Parallel operation: Connect CS pins, keep module voltage difference <0.2V, total power ≤1200W; Use short large-diameter wires

5 Remote control: Correctly wire RC2/RC3 pins (open=ON, short=OFF for modules)

6 Environment: Avoid condensing humidity, dust, corrosive gases/liquids

7 Maintenance: Inspect connections regularly, clean ventilation slots to prevent overheating

8 Overload: Do not exceed 1200W (front-end) or 240W (modules) rated power

NMP1K2-KKKKC#-06-PDF数据手册-参考资料