1 Modular design with 6 slots for NMP1K2, supporting up to 1200W total output power

2 Multiple output options including single (5V/36A,12V/20A,24V/10A,48V/5A) and dual output modules

3 Complies with medical (IEC60601-1) and ITE (IEC62368-1) safety standards

4 Comprehensive protection: overload (constant current limiting), overvoltage (shutdown recovery), overtemperature (auto-recovery)

5 Remote functions: remote sense (0.5V drop compensation), DC OK signal (TTL level), T-alarm (overtemp warning)

6 Current sharing capability for parallel module operation

7 Wide input range:90-264VAC or120-370VDC

8 High efficiency up to91% typical, low leakage current (<400uA/264VAC)

9 Auxiliary power outputs:5V/2A (front-end) and5V/10mA (modules)

1 Medical equipment (diagnostic devices, patient monitors) requiring medical-grade power

2 Industrial automation systems (PLCs, sensors, actuators) with multiple voltage needs

3 Test and measurement instruments (oscilloscopes, signal generators) needing stable power

4 Telecommunication and data center equipment (routers, servers)

5 Laboratory R&D environments for prototyping circuits

6 Embedded systems and industrial control panels

1 Installation: Follow recommended mounting torque (12Kgf-cm for front-end,10Kgf-cm for modules) and ensure ventilation

2 Derating: Reduce output current to90% when voltage <12V and temp between-15°C to-30°C; follow derating curves

3 Control signals: Install shorting connector for RC1-GND-P unless using global ON/OFF; local ON/OFF logic: open=ON, short=OFF

4 Parallel operation: Connect CS pins, keep voltage difference <0.2V, do not exceed1200W total power

5 Safety: Do not modify the unit; use approved accessories; disconnect power before maintenance

6 Auxiliary power: Do not exceed current limits (2A for front-end5V-AUX-P,10mA for module Vcc2)

7 Remote sense: Use twisted pairs for sense lines and avoid exceeding0.5V compensation limit

NMP1K2-KECECK-00-PDF数据手册-参考资料