Modular design with 6 slots for flexible output configuration

1 Maximum power output of 1200W (NMP1K2 model)

2 Wide input voltage range:90~264VAC or120~370VDC

3 Frequency range:47~63Hz

4 High power factor:PF>0.95@230VAC full load, PF>0.98@115VAC full load

5 High efficiency:Up to91% (full load with H/K modules at24V/48V)

6 Supports multiple output modules:5V(36A),12V(20A),24V(10A),48V(5A), each up to240W

7 Compliance with medical safety standards (2x MOPP isolation) and ITE standards

8 Built-in protection:Overload(constant current limiting), overvoltage(shutdown restart), overtemperature(auto-recover)

9 Remote control:Global ON/OFF (RC1 pin) and local ON/OFF (RC2/RC3 pins)

10 Auxiliary power:5V/2A (front-end) and5V/10mA (modules)

11 Remote sense function to compensate load wiring voltage drop (max0.5V)

12 Output voltage/current programming (PV/PC pins)

13 DC OK signal (TTL level) for output status indication

14 Temperature alarm signal (TTL level) for overtemperature detection

15 Current sharing capability for parallel module operation

16 Low leakage current:<400uA@264VAC, touch current<100uA@264VAC

17 Long hold-up time:16ms@230VAC75% load, 10ms@230VAC full load

Industrial automation systems:Powering PLCs, sensors, actuators and control panels

1 Medical equipment:Compatible with devices requiring2x MOPP isolation (diagnostic instruments, patient monitors)

2 Test and measurement instruments:Stable power for oscilloscopes, signal generators and analyzers

3 Communication systems:Powering routers, switches, base stations and telecom gear

4 Data centers:Supporting server racks, storage devices and network infrastructure

5 Industrial control systems:Factory automation lines, robotics and process control

6 Laboratory equipment:Research tools, prototype circuits and testing setups

7 Renewable energy systems:Integrating with solar/wind converters for stable DC output

Installation:Use M4 screws (7~10 Kgf-cm torque, max4mm penetration) and follow airflow direction

1 Derating:For voltages <12V at-15~-30°C, derate current to90% of rated value; follow derating curves for high temps

2 Global ON/OFF:Install shorting connector (RC1 to GND-P) if not using global control to enable output

3 Remote Sense:Use twisted pairs for +S/-S lines; do not exceed0.5V compensation limit

4 Parallel Operation:Connect CS pins of modules; ensure voltage difference <0.2V; total power ≤1200W; use short large-diameter wires

5 Temperature Handling:Monitor T-Alarm signal; power off and cool down if triggered

6 Auxiliary Power:Avoid exceeding limits (5V/2A front-end,5V/10mA modules)

7 ON/OFF Control:Distinguish global (RC1) vs local (RC2/RC3) control; check wiring for correct status

8 DC OK Signal:Verify output status via TTL level (4.5~5.5V ON,0~0.5V OFF)

9 Safety:Follow electrical guidelines; ensure proper grounding (FG pin) to prevent shock

NMP1K2-EKKHKE-00-PDF数据手册-参考资料