产品特点 FEATURES

1 Modular design with 6 slots (NMP1K2 model) supporting up to 1200W total output power

2 Compatible with multiple single-output modules (NMS-240 series:5V/36A,12V/20A,24V/10A,48V/5A etc.) and dual-output modules (NMD-240)

3 High efficiency (up to 91% typical at full load with H/K modules at nominal 24V/48V)

4 Compliant with medical (2x MOPP between primary and secondary) and ITE safety standards (ANSI/AAMI ES60601-1, UL62368-1, IEC 60601-1 etc.)

5 Supports global and local ON/OFF control for flexible power management

6 Built-in protection functions: over-temperature (auto-recover after cooling), overload (constant current limiting), over-voltage (shut down and re-power to recover)

7 Equipped with auxiliary power outputs:5V/2A (front-end) and 5V/10mA (module-level)

8 Features remote sense (compensates up to 0.5V voltage drop), DC OK signal (TTL level for output status), current sharing (for parallel operation)

9 Wide input voltage range (90~264VAC /120~370VDC) and frequency range (47~63Hz)

10 High power factor (PF>0.95 at 230VAC full load, PF>0.98 at115VAC full load)

使用场景 APPLICATIONS

1 Industrial automation systems (PLCs, motor drives, sensors)

2 Medical devices (compliant with medical safety standards for reliable power supply)

3 Test and measurement instruments (stable and adjustable power for diverse testing needs)

4 Telecommunication and networking equipment (supports multiple voltage requirements)

5 Laboratory research setups (flexible modular configuration for varied power demands)

6 Embedded systems and industrial control panels (compact design fits standard enclosures)

7 Critical backup power systems (reliable performance and comprehensive protection functions)

注意事项 PRECAUTIONS

1 Ensure the shorting connector (RC1 to GND-P) is properly installed for normal operation of the power supply

2 When using remote sense, twist +S and -S lines in pairs to reduce interference

3 For parallel operation: connect CS pins of modules, ensure voltage difference between modules <0.2V, do not exceed 1200W total power

4 Derate output current at high ambient temperatures (refer to derating curves; e.g.,90% of rated current at -15~-30℃ for output voltages below12V)

5 Avoid exceeding maximum load current of each module and total load of the power supply

6 Follow correct wiring for local ON/OFF control (RC2/RC3 to GND for desired output status)

7 Adhere to mechanical installation guidelines (screw torque, penetration depth) for stable mounting

8 Do not use PC function when modules are in parallel operation

9 For medical applications, comply with relevant local regulations and guidelines

NMP1K2-CEKECH-00-PDF数据手册-参考资料