1 Modular power supply (NMP1K2 model) with 6 slots, supporting up to 1200W total output

2 Single output modules (NMS-240) available in 5V/36A,12V/20A,24V/10A,48V/5A; dual output modules (NMD-240) with two 30V/5A outputs

3 Wide input voltage range:90~264VAC or120~370VDC, 47~63Hz frequency

4 High efficiency up to91% (typical at full load with 24V/48V modules)

5 Complies with medical safety standards (2x MOPP isolation) and ITE standards (ANSI/AAMI ES60601-1, UL62368-1)

6 Comprehensive protection: overload (constant current limiting or shut down), overvoltage (shut down), overtemperature (automatic recovery)

7 Flexible control functions: global/local ON/OFF, remote sense (compensates up to0.5V voltage drop), output voltage/current programming (PV/PC pins)

8 TTL-level signals: DC OK (output status) and T-alarm (overtemperature warning)

9 Current sharing capability for parallel operation of modules

10 Auxiliary power outputs:5V/2A (front-end) and5V/10mA per module

1 Installation: Use M4 screws (7~10 Kgf-cm torque) for front-end; M3.5 screws (10 Kgf-cm) for modules. Follow airflow direction guidelines

2 Derating: For output <12V and -15°C~-30°C ambient temp, derate current to90% rated. Refer to derating curves for high temps

3 Global ON/OFF: Install shorting connector (RC1 to GND-P) if not using global control; else no output

4 Parallel operation: Connect CS pins, ensure voltage difference <0.2V between modules, max6 slots for NMP1K2; avoid PC function in parallel

5 Blank slots: Use BLANK-NMS240 accessory for empty slots

6 Remote sense: Use twisted pairs for sense lines; do not exceed0.5V compensation

7 Safety: Disconnect AC before installation/maintenance; ensure proper grounding; avoid touching live parts

8 Accessories: Use recommended connectors (HRS DF11 series) for terminals

NMP1K2-#KKECK-02-PDF数据手册-参考资料