1 Modular design with 6 slots for NMP1K2, supporting up to 1200W total output power

2 Multiple output module options: single-output NMS-240 (5V/36A,12V/20A,24V/10A,48V/5A) and dual-output NMD-240 (30V/5A each, combined 240W)

3 Flexible control functions: global ON/OFF (via RC1 pin) and local ON/OFF (per module via RC2/RC3 pins)

4 Remote sense capability: compensates voltage drop on load wiring up to 0.5V using +S/-S pins

5 Output customization: voltage programming (PV pin) and current programming (PC pin) for precise output adjustment

6 Status monitoring: DC OK signal (TTL level) indicates module output status; T-Alarm signal alerts over temperature

7 Parallel operation support: current sharing (CS pin) for balanced load distribution among parallel modules

8 Comprehensive protection: overvoltage (OVP), overcurrent (OCP), overtemperature (OTP) protections

9 Medical isolation compliance: meets 2x MOPP requirements between primary and secondary circuits

1 Installation: Use M4 screws with 7-10 Kgf-cm torque; ensure proper air flow direction

2 Connectors: Employ HRS DF11 series connectors for control pins

3 Derating: Reduce output current to 90% when ambient temp is -15°C to -30°C and output voltage <12V

4 Remote sense: Twist +S/-S wires to minimize interference

5 Parallel operation: Connect CS pins of modules; ensure output voltage difference <0.2V; total power ≤1200W

6 Global ON/OFF: Install shorting connector between RC1 and GND-P if not using global control

7 Over temperature: Check load and ambient temp when T-Alarm signal is high

8 Module compatibility: Do not mix incompatible voltage modules without verification

NMP1K2-#KCKKE-00-PDF数据手册-参考资料