产品特点 FEATURES

1 Modular design with 6 slots for flexible output configuration, supporting modules like 5V/36A,12V/20A,24V/10A,48V/5A

2 1200W maximum total output power

3 Complies with medical (2x MOPP) and ITE safety standards (EN60601-1, UL62368-1 etc.)

4 High efficiency up to 91% (typical) at full load

5 Multiple protection functions: Overload (constant current limiting), overvoltage (shutdown, repower to recover), overtemperature (auto recovery or shutdown)

6 Remote management capabilities: Global/local ON/OFF control, remote sense (compensates up to 0.5V voltage drop), DC OK signal (TTL level), T-Alarm for overtemperature

7 Supports current sharing for parallel module operation to balance load

8 Auxiliary power outputs: Front-end 5V/2A, module-level5V/10mA

9 Wide input voltage range:90-264VAC or120-370VDC; input frequency range:47-63Hz

10 Low ripple and noise: Modules have ripple values from100mVp-p (5V) to250mVp-p (48V)

11 Precise line and load regulation (e.g., ±0.2% for24V/48V modules)

使用场景 APPLICATIONS

1 Medical devices: Suitable for patient monitors, diagnostic equipment and laboratory instruments due to medical safety compliance

2 Industrial automation systems: PLCs, DCS and industrial controllers requiring multiple stable DC voltage outputs

3 Test and measurement setups: Lab environments needing configurable power parameters

4 Telecommunication equipment: Network devices, routers and switches requiring reliable multi-voltage power

5 Data center peripherals: Auxiliary power for server racks or associated devices

6 R&D prototyping: Flexible power supply for product development and testing

注意事项 PRECAUTIONS

1 Installation: Use M4 screws with7-10 Kgf-cm torque for mounting; fill unused slots with BLANK-NMS240 modules to ensure safety and airflow

2 Operation: Do not exceed total power (1200W) or module power (240W per module); for parallel operation, connect CS pins of modules, ensure output voltage difference <0.2V between parallel modules and use short/large diameter wires

3 Remote sense: Use twisted pairs for sense lines to minimize interference

4 Temperature derating: Follow derating curves (e.g., when output voltage <12V and ambient temp is -15~-30°C, derate current to90% of rated)

5 ON/OFF control: Confirm correct wiring for global (RC1) and local (RC2/RC3) control (open=ON, short=OFF for local)

6 Safety: Disconnect input power before maintenance; ensure proper grounding to meet leakage current requirements (<400uA at264VAC)

7 Storage: Keep in dry environment (-40~+85°C,10-95% RH non-condensing) when not in use

NMP1K2-#CEEHK-03-PDF数据手册-参考资料