产品特点 FEATURES

1 Constant current mode output with rated current 700mA (adjustable range:350~700mA) and rated power100.1W

2 Wide input voltage compatibility:100~305VAC (47~63Hz) or142~431VDC

3 High efficiency up to91% and built-in active PFC function (PF≥0.97@115VAC, ≥0.95@230VAC, ≥0.92@277VAC full load)

4 IP67 protection rating, suitable for both indoor and outdoor installations

5 Metal housing design with functional ground for safety and durability

6 Low no-load/standby power consumption (<0.5W) to save energy

7 Multiple protection mechanisms: over temperature (shut down, re-power to recover), over voltage (shut down, re-power), short circuit (hiccup mode, auto recover after fault removal)

8 DA-Type supports DALI interface (16 groups,64 addresses, first step fixed at8% output) for flexible dimming control

9 3Y model features 3-wire input for standard use

10 Wide operating temperature range: case temperature -40~+90℃, ambient temperature -40~+80℃

11 Long service life: >50000 hours when case temperature is ≤80℃

12 5-year warranty for reliable after-sales support

使用场景 APPLICATIONS

1 LED street lighting systems

2 LED harbor lighting applications

3 LED bay lighting in industrial or commercial spaces

4 LED greenhouse lighting for plant growth

5 LED flood lighting for outdoor areas like stadiums or squares

6 Type HL application in Class I, Division2 hazardous (classified) locations (applicable for700mA model)

7 Residential lighting with smart timer dimming (D01-type profile)

8 Street lighting with adaptive dimming (D02-type profile)

9 Tunnel lighting with scheduled dimming (D03-type profile)

注意事项 PRECAUTIONS

1 Always connect the case to protective earth (PE) for complete EMC performance and safety.

2 De-rating may be required under low input voltages; refer to the "STATIC CHARACTERISTIC" section in the specification for details.

3 The driver is a component; final equipment manufacturers must re-qualify EMC compliance for the complete installation.

4 For DA-Type models, the constant current region is60%~100% of the maximum voltage under rated power delivery.

5 The set-up time increases with repeated ON/OFF cycles; initial measurement is based on first cold start.

6 For IP waterproof function installation, refer to the user manual before operation.

7 D2-type models need to be programmed in the loading state.

8 Comply with ErP regulations: the driver should be used behind a switch and not permanently connected to the mains.

9 For A/AB-type models, consider built-in use to meet Type HL application requirements.

10 When using dimming functions (B/AB-Type), do not connect DIM- to Vo-; the minimum dimming level is approximately8%, and output current is undefined between0%~8%.

11 For operating altitudes higher than2000m, ambient temperature derating applies at3.5℃/1000m for fanless models

ELG-100-C700DA-3Y-PDF数据手册-参考资料