1 Wide 2:1 input voltage range (9-18V for AM8T-1212DZ model)

2 Dual output configuration with ±12V voltage and ±335mA maximum current

3 24-pin DIP package for easy integration into circuit boards

4 High efficiency up to 84% (for AM8T-1212DZ) to minimize power loss

5 Over Current Protection (OCP) and Continuous Short Circuit Protection with auto recovery function

6 Low ripple and noise performance for stable output signals

7 Input-output isolation voltage of 1500VDC for enhanced electrical safety

8 Operating temperature range of -40°C to +85°C, adaptable to harsh environmental conditions

9 Compliance with CE, cULus, and RoHS standards for global safety and environmental requirements

10 Capacitive load tolerance up to ±220 uF for stable operation with reactive loads

1 Industrial control systems: Powering sensors, actuators, and microcontrollers in PLCs and DCS

2 Telecom and networking equipment: Providing regulated power to transceivers, routers, and switch modules

3 Instrumentation and measurement: Supporting precision devices like oscilloscopes, data loggers, and signal analyzers

4 Embedded systems: Integrating into single-board computers and embedded controllers for IoT and automation applications

5 Medical equipment: Suitable for low-power medical devices (e.g., patient monitors) due to safety approvals

6 Automotive electronics: Powering vehicle-mounted devices like GPS trackers under varying input conditions

7 Renewable energy systems: Supplying power to monitoring and control circuits in solar inverters and wind turbine controllers

1 Operate within the specified input voltage range (9-18V for AM8T-1212DZ) to avoid device damage

2 Follow temperature derating guidelines: Reduce output power when operating above 60°C (refer to the derating curve)

3 Use recommended external components (e.g., 12uH inductor and 100uF capacitor) for conducted emission suppression

4 Do not exceed the maximum capacitive load limit (±220 uF for AM8T-1212DZ)

5 Handle with ESD protection during installation to prevent static damage

6 Ensure proper heat dissipation: Mount in a ventilated area or use a heat sink if needed

7 Do not directly connect input and output terminals to maintain isolation safety

8 Comply with all relevant safety standards and regulations

9 Check the latest datasheet specifications before use as they may be updated

10 Avoid using in applications where failure could cause injury or property damage without additional safeguards

AM8T-1212DZ-PDF数据手册-参考资料