1 Model: AM3T-2424S-RZ, brand: Aimtec, power rating:3W DC-DC converter

2 Input voltage range:18-36V DC (wide 2:1 input range)

3 Output voltage:24V DC, maximum output current:125mA

4 Isolation voltage:1500VDC between input and output

5 High efficiency up to82%

6 RoHS compliant and CE certified

7 Auto recovery short circuit protection, continuous short circuit protection with current limiting (20% of output max)

8 Operating temperature range:-40°C to +85°C (full load without derating)

9 Low profile metal package, built-in stand-offs for PCB mounting

10 Pin compatible with multiple manufacturers' similar models

11 Capacitive load tolerance up to470uF (max)

12 Switching frequency:266KHz (typical at 100% load)

13 Long MTBF:>121000 hours (per MIL-HDBK-217F, Ground Benign, +25°C)

1 Industrial control systems: Powering sensors, actuators, or control modules in automated production lines

2 Telecom and networking equipment: Providing stable voltage for embedded components in routers, switches, or communication devices

3 Instrumentation and measurement devices: Powering precision sensors or display units in test and measurement equipment

4 Embedded systems: Used in IoT devices, single-board computers, or portable electronic devices requiring isolated power conversion

5 Battery-powered equipment: Suitable for devices with varying battery voltages (due to wide input range)

6 Automation and process control: Powering low-power components in PLCs (Programmable Logic Controllers) or DCS (Distributed Control Systems)

7 Consumer electronics: Used in devices that need isolated DC power conversion for safety or noise reduction

1 Ensure input voltage is within the specified range (18-36V DC) to avoid damage to the converter

2 Do not exceed the maximum output current (125mA) for prolonged periods to maintain performance and reliability

3 Operating and storage temperature must stay within -40°C to +85°C; avoid exposure to extreme temperatures outside this range

4 Capacitive load connected to the output should not exceed 470uF to prevent instability

5 Follow the recommended test circuits for conducted emissions and surge protection as outlined in the datasheet to meet EMC requirements

6 The product is not designed for use in critical life support systems, hazardous environments, or nuclear control systems (per manufacturer's note)

7 Ensure proper PCB mounting using the built-in stand-offs; avoid mechanical stress on the pins during installation

8 Isolation voltage of1500VDC must be respected to prevent electrical hazards or performance issues

9 In case of short circuit, the converter will auto-recover once the fault is removed; however, frequent short circuits may reduce lifespan

AM3T-2424S-RZ-PDF数据手册-参考资料