1 Brand: Aimtec; Model: AM1P-050909DZ; Series: AM1P-Z (1 Watt dual output DC-DC converter)

2 Input Voltage Range: 4.5V~5.5V DC

3 Dual Output: ±9V DC, Max Output Current: ±9mA per channel

4 Isolation: 1000V DC (tested for 60 seconds)

5 Package: 8-pin DIP, compact dimensions (12.70×10.16×6.85mm approx)

6 Efficiency: 77% (nominal conditions)

7 Compliance: RoHS compliant, CE certified

8 Operating Temp: -40°C~+85°C (full load without derating); Storage Temp: -40°C~+125°C

9 Key Electrical Specs: Low ripple & noise; Line voltage regulation ±3% (typical); Load voltage regulation ±20% (typical)

10 Compatibility: Pin-compatible with multiple manufacturers' similar converters

11 Max Capacitive Load: 100uF per output channel

12 Safety Standards: Meets EN55032 (EMC class B with recommended circuit), IEC61000-4-2 (ESD), etc.

1 Industrial control systems: Powering low-voltage sensors or control modules in PLCs/DCS

2 Embedded electronics: Supplying stable ±9V to microcontrollers, op-amps, or signal processing circuits

3 Test & measurement equipment: Portable meters, oscilloscopes, or signal generators needing isolated dual voltage

4 Communication devices: Transceivers, modems, or RF modules requiring dual ±9V inputs

5 Medical devices: Low-power instruments like blood glucose monitors (compatible with safety standards)

6 Automotive electronics: In-vehicle infotainment or sensor modules (suits wide temp range)

7 Consumer electronics: Audio amplifiers or equalizers needing clean dual voltage supplies

8 Battery-powered devices: Efficient conversion for portable tools using 5V battery packs

1 Ensure input voltage stays within 4.5V~5.5V DC to avoid damage

2 Do not exceed max output current (±9mA/channel) or capacitive load (100uF/channel)

3 Use recommended external components (capacitors, inductors) to meet EMC standards

4 Operate within -40°C~+85°C; derate if used beyond specified temp range

5 Follow correct pin configuration to prevent reverse polarity or short circuits

6 Handle DIP package carefully to avoid bending pins; solder at recommended temps

7 Store in dry environment (max 90% humidity non-condensing) and avoid extreme storage temps

8 Maintain proper isolation between input and output circuits per safety guidelines

AM1P-050909DZ-PDF数据手册-参考资料